6.5 creedmore loads

Awesome all great info thanks I'll be running Norma brass and cci br2 primers I think , we don't have a choice for primers atm but I think I have a thousand of them so should get me started
 
Just run it up on quickload looks abit anemic, I was under the impression our adi 2209 was the same as americas h4350 but it must be different?
 
Just run it up on quickload looks abit anemic, I was under the impression our adi 2209 was the same as americas h4350 but it must be different?
It looks to be similar to IMR 4350 not H 4350. I am new to reloading but I do believe there's a difference in these two powders. How much I am not sure. But I am sure some of these guys will tell you. lol
ADI AR2209 is a fine grained moderately slow burning rifle powder. Commonly used calibres include: 22-250 REM 243 WIN 270 WIN 30-06 SPRG 300 WIN MAG AR2209 has a similar burn rate to IMR4350 but with a higher density that meters through a powder loader far better. ADI AR2209


I believe Ramshot Hunter is supposed to be close to H 4350. But again I have no experience using this powder yet. And have not compared the two. I hope others chime in. Because I am also curious to the loads for 6.5 CM using small primer pockets. And the large. But more with the small PP using CCI 450s. Fed 205M.

 
Last edited:
1688308507252.png
 
For 65 CM, I use 140s over H4350 and Winchester Staball 65. In US, H4350 became hard to find so I switched to Staball 65 - I prefer H4350. I do not believe that loads with 65CM small primer with CCI450 would be any significant difference that Federal 210 large primers I normally use. An advantage of 6/65CM is small primer brass is available.
 
Last edited:
Top