grouse
Well-Known Member
anyone cut down a proof? I have an hca carbon that was cut down on a lathe. No issues at all. Anyone tried a proof?
-
If you are being asked to change your password, and unsure how to do it, follow these instructions. Click here
Cutting down a proof carbon?
- Thread starter grouse
- Start date
Help Support Long Range Hunting Forum
grouse
Well-Known Member
Anyone?
Mikecr
Well-Known Member
A barrel is 'cut' to shorten. It's 'turned' to affect diameter. Proof finishes their own barrels, so I don't see how they could be altered locally.
cohunt
Well-Known Member
I think proof are tensioned barrels and you need to leave some of the full diam barrel at the muzzle-- icbwt
I would think it would be a little hard to make a tensioned barrel when the blank that is wrapped is monolithic. If the muzzle end was screwed on then I can see it but Proof barrels aren't. I guess if you stretched the barrel somehow, wrapped it, and then let it go you could put it under tension but it would distort the bore and most likely cause hell with the accuracy.
codyadams
Well-Known Member
HCA specifically states somewhere on their site that they do their wrap differently, so that it can be cut to your chosen length. I would think that based on the fact he states he does it differently so that this is possible, his biggest and most widely known competitor wraps it in a fashion that prevents you from cutting down.
But I'm just some guy on the internet (along with every other person responding here) so why don't you just call this number on monday and get your no BS answer:
(406) 756-9290
Proof Research
But I'm just some guy on the internet (along with every other person responding here) so why don't you just call this number on monday and get your no BS answer:
(406) 756-9290
Proof Research
grouse
Well-Known Member
Proof says no. I've watched how they wrap their barrels and I don't see anything special about it. Thinking about trying this. Anyone else done it?
FireFlyFishing
Well-Known Member
Negative. Order a new barrel to desired dimensions.
grouse
Well-Known Member
New barrel = 1000 after smith work. Cutting and threading = 100. Seems like it would be worth a try.
FireFlyFishing
Well-Known Member
Perhaps. I think I'd pay the $1000 for the new barrel and sell the old one unaltered to offset the cost. If you cut the barrel and things go bad, then it's completely worthless.
FireFlyFishing
Well-Known Member
How much did this run you?
grouse
Well-Known Member
So the groups opened up quite a bit! Ha ha
To me at my gunsmith....$50
No....1/2moa at 400yds.....2".....they were sometimes 1.75".....
Cut and and reset of load went to 7/8".....
I think at 100yds that is something like .18"......
