xsn10s's latest activity

Forster Dies, have given Me the Least "Run Out" and BEST Accuracy as they Position, the Expander Ball, Near the Top of Case !. And you...

My groups at 550 yards with off the shelf dies and a Remarms 700 ADL. Any fitting to seater stems or polish of dies I do myself. And the...

I'd check your cases after resizing them. If you use an expander ball improperly adjusted/ centered can cause case/ neck runout. As far...

What do you believe is the biggest cause for bullet runout, press or dies? I know from experience, I have seen one show very little...

Back when I had a .270Win, I had a 130 NBT load for deer @ 3150, and a 150 VLD load for elk @ 3020. Both shot equally well. Once I...

Here's a shot in my Remarms 700 ADL. This is Remington's cheapest 700 in their line up. Yours is basically their flagship model. I'd...

The rifle is fired at the factory to insure it's in good working order. That's common practice for all legit firearms builders. The...

I have experienced a lot of tough situations in my life but this is by far the toughest, mainly because I can’t do anything to help her...

I know when I tested rifles I usually checked headspace, then fired a proof round to make sure everything held together. Then checked...

Prayers up again for your family.

Prayers up for a long, healthy and happy life for Chelsea.

I’m sure a lot of other do the same but I check this thread a lot and am praying for you all.

Right now her condition hasn’t changed except for the brain swelling which they have under control. She has been off sedation for the...

12.5ft/lbs is 150in/lbs. I don't know of any use that could be for rifle/scope work.

Snap-on for my torque wrench. Wera torque screwdriver.