Will.284's latest activity

All tikkas, I don't do favorites because I can't pick one... All 18-inch carbon six barrels, 6.5 & 7 saum New this year a 300wsm, in pic...

I use a Rem Mod 7 in .308. Bought it the first year it came out and have owned it for 42 years. Original wood stock was replaced with...

Sig cross in 6.5 creed with scope and bipod and 5 rounds in the mag 8 lbs

My speeds today from a 21” barrel

Really thinking about doing this with a 18" bartlein 7.5 twist... Have plenty of ADG brass, N565 and all I'd need is a bushing for the...

I have only used the ELDX line twice in my 6.5 x .284 for moose and there also have been know exit wounds . Both animals less than 100...

Can you tell me what speeds you are getting with the 195? Thanks.

We have killed a bunch of elk from 60 to 882 with my original belted 7PRC shooting 180 Hybs @ 2996fps...

I had a bad experience with the 175 ELDX out of my 7 PRC. I did not have a chance to hand load for it so used Hornady factory rounds...

First off I am no expert, but I think sometimes we are asking a lot if not the impossible from these bullet manufacturers. You want a...

ELD-X is not a close range bullet especially if it’s moving good at the start.

That is great info on the freebore length. do you know the reamer spec as far as freebore diameter? It makes a difference getting to the...

I have no idea honestly. High Voltage Armory has the reamer and did the build.

I would be careful with that 70 grain charge. My 264 is throated long and I run into pressure around 71 grains of Retumbo with 140s. The...

My reamer was set up for the 156 and the ones I have built all liked the n565 and was pushing the 156 right at that 3200 mark.