wilkup's latest activity

Nice setup

Nice rig for AK We just came back from an eight-week road trip up North, a few years ago we did six weeks on Dalton HWY up and over...

Picked up a killer chest holster from a local buddy for my trip to AK! Got a couple loads dialed the past week and took the advice about...

If you do try powder coated bullets……likely, you'll never go back. A lot more shooting before mandatory cleaning, the coated...

Gas checks will help with fitment issues. A softer alloy can help also as the bullet can obturate to fill the cylinder throats...

If your cast bullets are sized correctly they don't need to be coated. If you are purchasing them,you probably don't have any control...

Cimarron Bad Boy. This is the only photo I can upload. I keep getting an error uploading all the other ones for file being too big. If I...

Take a bullet and see how snug they are in your chamber throats. I'm guessing they drop through. Curious what revolver you are using?

Unless you get them “hospital sanitary”…..you may have issues with powder coating. memtb

Yea, just checked it. Maybe I need to heat the lube off and powder coat…

Is that bluing blasted off or lead deposits? Fitment is critical with cast bullets, especially when they are hard cast and not gas...

Not sure on cylinder dimensions but bullets are .429 Could it be caused by undersized bullets? Edit* Cylinder dims - .431”

Pulled my cylinder to clean the gun and noticed the bluing was blasted? off during the 3 latest firings….? Can anyone tell me what’s...

Have not loaded the Jacks yet. T.P.

Just for “research,” I loaded up three rounds w/16.5gr H110 and chronographed them to compare with that 1680 load. 1084’ 1084’ 1079’ I'm...