waveslayer's latest activity

As with anything else, YMMV. I prefer loading CBTO to the lands regardless of chambering.

I would see what my chamber says. Then you know for certain.

I think neck tension may part of this problem not sure 🤔

TBAC magnus would be my next purchase

The Hybrid is likely impossible to beat for the $$, but the TBAC cans are just fantastic! I know its "overkill", but I screwed my TBAC...

For mandrel use I’ve always used imperial sizing wax. Granted I’m expanding up .020 so the wax helps a ton. And as said above, clean all...

I use graphite in the necks. Be careful that you don’t load powder right after the one shot because it can cake the powder if it’s not...

TBAC 338 ultra Omega 300

Good luck! Most barrels are threaded differently on where they start the cuts for the threads, so timing has to be done by washers. Or a...

Shim kits come with an assortment of different thicknesses. Just use the one that you can torque into position. I add blue loctite.

Ditch the sled it’s been said many times for many different reasons.

MDT has some nice stuff and their bottom metal is great, haven't had any issues with them at all. I also use Badger Ordinance, but...

7RSAUM no real hinderance really.. built a Shizz ton of them on short actions and they pound..

Hooked up the camper in a hailstorm that whitened the ground for the roadtrip to Wamsutter to try to fill a 57 that took 6 years to...

I have had really good luck with Whidden for custom dies, I haven't had to try anyone else though