VinceMule's latest activity

OP, the bullet did it's job! The bullet expanded with massive damage inside, with the base or core exiting. I butcher my deer. A...

Neck dia of the sizing die also comes into play if you are not using a bushing type of die

I would not like necks so thick, either 14thou for Barnes, nor over 15thou for Lapua. And the barrel finisher should have engraved...

Looks like under 100 rounds

Those 95g SST are super deer killers!

It worked like a charm forming brass, then I discovered a 4000+ degree burn temp along with the rest. But R23 netted a tad over 3550...

I’m not sure about your requirements for precision. But shooting year around in Mississippi means 20-90+ degrees. If a 70* temp swing...

560 is fast and hot burning, just not stable. I can’t imagine compressing it, maybe 565, for sure 568/570 though.

That throat looks good to me, barrel is a little rough, however that’s not a game changer. I would have no qualms shooting that barrel...

Doughnuts WILL form in the necked down brass. Learn to deal with this issue, how to detect doughnuts and how to remove them...

I would bore scope the barrel after cleaning...make a decision if the barrel is toast.

As Eric H asked, trimmed? Or turned? Sounds like you "turned" them if it was a diameter problem. If virgin brass didn't fit...

Tight brass causes pressure to climb, it cannot expand and it slams your bolt lugs tight into the action, this is why you get YOUR...

Nathan is the man when it comes to bullet performance. I've been reading his works for quite some time. He also compares bullet...

Pick your poison. 1. Hit light & fast with frontal opening bullets with solid shank follow through. 2. Hit slower with more mass and...