Recent content by TJH

Your front scope mount screws are probably to a bit to long. The rear one might be contacting the bolt locking lug when closing the bolt. The bolt would only get hard to close in the last half of closing as you describe if the screw is bit to long. If the front screw is to long it could be...

I will take the Magpul mlok FDE 50.00 shipped Sending PM TJH

Did you try lowering the expander ball/decapping pin as low as possible in the sizing die to get it down in the body of the case?

PM sent

I will take it. Sending PM for payment info. TJH

I will take it. Sending PM for payment info. TJH

I will take it for $75 shipped. Sending PM for payment info. TJH

You usually can not use the same wad in a Federal hull as you use in a AA hull. Federal is a straight wall hull AA is a tapered wall hull. Follow the published data which will list the correct wad, powder, and primer for a specific hull, no substitutions and everything will work. I have been...

I will take the 10" Skeleton Buttstock for $50 shipped. Sending PM for payment info. TJH

I will take it. Sending PM for payment info. TJH

I will take #4-Gamma 6.5 VG6 and crush washer- $45 shipped Sending PM TJH

I will take the green stock for $100 shipped. Sending PM for payment info. TJH

Seconds if something does not work out. Thanks

I will take it for $285 with a precison remage nut. Sending PM for payment info. TJH

I will take it for $167 shipped. Sending PM for payment info. TJH