Taylorbok's latest activity

I've gone both ways. I recently did a seating depth test that had .180" difference total and there was no noticeable change in pressure...

If you had oil/solvent left in the chamber after cleaning, what you describe mirrors the results of what you saw. It is NOT high...

Yes, I picked one up on this site from a member here. Like new condition.

Tell him to separate the gun (incl scope) into a couple dumpsters and be done with that mess.

Someone make claw feet for that Hatch Bipod?

My point was something else is at play here. The seating depth isn't enough to cause this issue. The same as @MagnumManiac, I've gone...

Nope. Just did it to see if the BS about jamming a normal load from .010" off to .030" jammed did what was claimed. It did raise...

I no longer reply to these type of threads, but I will say, I have deliberately jammed bullets by .030” and never seen a rise in...

Like as in, if you were already way over charged seating the bullet deeper isn't going to fix that.

Do you have a regular vise? Does it have any type of thread locker (Rocksett, LocTite, etc.) on it? If you have a regular vise, you...

Ya, there's no way the seating depth change was the cause of that.

Is there a chance you turned the seating stem out instead of in, and ended up with .028” jamb?

I could understand not wanting to shoot another one after seeing that, but curious if this was a one off that was waaaaay over charged...

I think there should be 5000 more threads about cold welding so we can continue to debate the condition and effects...like a bear...