Taylorbok's latest activity

I just packed all my stuff as I intended to carry it and went for it. those weights wont carry the same as a fully loaded pack.

Really sad to hear they aren't doing custom dies anymore, I've had phenomenal experience with them.

Yes. Unless you are shooting elk at 800+ yards. Which, asking how to tame a gun tells me you're not.

Muzzlebreak

I'd use Hornady, used a lot of Whiddens and just won't again, the upper end Hornady is an outstanding die without a bunch of gimmicks!

IIRC, they only do dies once a month. My WAG is they are temporarily suspending it because they are overwhelmed and do not want more...

Hornady will make you a custom die based on prints or fired brass .... Whatever you want. You just have to call them and work it out...

Unfortunately Whidden isn’t accepting new custom die orders, last I looked at their site. Was thinking about a clicker adj bushing sizer...

Just to clarify the term "going deeper" usually refers to seating the bullet deeper into the brass; not deeper into the chamber of the gun.

Yes, and per my #3 comment, one of the reasons I went with NM over LM. Below is my .338 Thor next to .338 NM.

I've done the sizing reamer way and the Whidden route. It sucks whidden isn't doing custom dies right now, hopefully that comes back...

300 Norma Mag Imp. 33 or 35°.

My SAKO M995 is in .300 WM. Depending on the bullet you are going to load and unless your action have a COAL of 4.00” I would go with...

I haven't used the ALPS cot but I have several of their products and have been thoroughly impressed with them all, I'm sure the cot is...

I have the ALPS outdoorz XL Camping Cot which is 86"x40". ALPS stuff is usually sourced overseas, but this one has done the trick no...