Taj's latest activity

Yes sir! I didn't go at it with a shop hammer! LOL! I have a small machinist hammer. It probably weighs 2 ounces. Just a gentle tap...

Need to be a bit careful trying this. Most dies only have a carburized surface treatment which may not be that thick. They can be...

Stuck case removers do not need a rim. They go inside the case and lock onto the mouth of the stuck case . Another method is to find...

I just discovered this mold! 🤯 Being a little limited due to a shorter cylinder length than the Freedom Arms and Ruger Blackhawk, I...

Got those 370gr MBW in the mail today and put together a dummy round. I don’t get my gun until Friday so I’ll have to swing by and make...

My co pilot. He likes to lean out and bite branches. Endup with branches and leaves all over back seat.

Criterion. Best shooting/ bargain barrel out there. All I used for high power matches over the years

CMMG pioneered the radial delay blowback. To my knowledge they only use it as a replacement for direct blow back in pistol cartridges to...

I always felt that just because my corvette can run 140 mph doesn't mean that is what I should drive it at. And I'm that way with my...

I've shot more than a few critters with a 240 -320 hardcast and have had great success. These days I'm leaning more toward the 320 grain...

Where legal, I'm a fan of the hard cast WFN. Used to use the 240 gr XTP. Expansion was violent and only got pass through when broadside...

I load only 285 gr LSWC in 44 mag. Very effective projectile. Big hole in and bigger hole out

A-tip Yeah, your right, I am downloading it a bit. I have seen 3600 + fps with no pressure signs but I wasn't getting the accuracy I...

Have a couple but I'm really starting to fall in love with my .22-243 Middlestead. 70 grains at 3400 fps really reaches out and touches...

I have a couple of old model 70s in that caliber. I really like it. Recoil is fairly mild and it seems to be easy to load for. One of...