std7mag's latest activity

Expect a lot of….jello internals when field dressing.

Back when I was just a lad, (1984) my first rifle purchase was a new Savage 110 in 30-30. I remember topping it with a Simmons scope...

PPU brass in all cartridges is very good brass. It tends to be heavier than NA made brass and takes pressure well. It also has lower...

On the subject of brass, I just started a bag of PPU brass that seems quite a bit tougher than the Winchester, Remington or Hornady. I...

Link below for some good info on the BOSS, you should be able to tune to most any load/bullet combo. In my experience, I have 3 BAR's...

I used to have an old Savage or Stephens, can't remember for sure, bolt action 30-30, and with IMR 3031 I believe loaded some fantastic...

Same for me. Then I just print out a dope card for the area I'll be hunting and tape it to my stock to avoid any reliance on electronics.

That's why I use MOA reticles in my scopes. MOA/MIL is always MOA/MIL.

X2. I am PLENTY satisfied with the Hammer Hunter line.

Try Staball 6.5, i had good luck with it in my long throated 284 with a few bullets, all of em copper.

Like new Meopta Meosport R 3-15x50 RD SFP scope with factory rings, box, and paperwork for sale. Sold the rifle it was on and cleaning...

As @RockyMtnMT said, the Absolute Hunter likes a faster burning powder for bullet weight. When they first came out, I had seen where...

The 7 mag will respond well to the Absolute design. As in added velocity from the lower engraving pressure. The older inefficient...

I hope if doesn't to come to fight.

I think there was a reason some folks placed the dead on platforms. Especially in winter frozen ground. Its the third S that is...