Recent content by Sniper97

I too have tried everything, I don't get why I just can't get an eta on my reamer.

It began with gas flow around the primers, but later turned into primers falling out of the case.

You are correct sir. Still amazed at how well it shot though!

Shot in about 20 degrees on previously fired brass.

Any pressure issues?

I sadly have come to the conclusion that I need to back my load down. I was achieving 3000-3025 with the 156 and RL26. Shot like a dream today, but blew 5 primers and had some nasty ejector swipes. I am all for running stuff hot, but it has become unsafe in my rifle. Will begin testing with a...

Can a loaded round clear or eject, or do you have to take the bolt out?

What is the difference between the 2?

What is the difference between the xc and the 6 creed?

Thanks for your input. Looking at the ULTRA 7, but cannot find one in stock to order and start the process.

How is the recoil reduction compared to a brake?

Just had this happen yesterday in my 6.5-284 norma with Lapua brass. Don't know where I went wrong. Gun shoots lights out.

So you think my best bet would be to try the 178?

I am loading for a friend that has a new Winchester model 70. I was thinking I would use either the 200 or 212 elder from hornady. However, I had to shove the bullet super deep into the case. The magazine box is a hinged floor plate. With the 200, I had to jump it 115 thousandths just to get it...

How would this compare to a 28 nosler? Assuming a longer freeborn with the 28 also. First glance I would say less powder for similar speeds? What are the chances of this hitting the market? How about barrel life? Thanks!