skipglo's latest activity

AIR TECH LIMBSAVER! I'm not sure why so many people want to look at the front end of gun first before looking at the back....it's the...

Run with it and watch the classifieds here for a 6.5 cal brake. What thread pattern is the barrel threaded, 1/2-28 or 5/8-24?

Weird! I just tried it under a new account got the same thing....maybe you need a first year subscription and then after that it's free...

Looks 40 moa to me.

Rail definitely isn't made for that gun....but I say 20.....

Looks like something greater than zero, but the only way to know for sure is take a measurement at the front and rear and see if there...

It was awesome at 34.00/ yr.....and far better now that ITS FREE! I paid for it for 6 years first. It is totally non- biased...gives...

Two factor authentication is the secret I hard to hack password is a given, but with the recent revelations about how much of your...

I'm not convinced of Lapua being any better than other brass. I've not had a good experience with the first 100 pieces especially at 2-3...

I stopped worrying about powder temperature sensitivity for some time now. Regardless of powder, I usually start my load development...

Go to LOAD DATA.COM.....only 310,000 loads available to you...not prejudiced by any manufacturer....site is by Gun Digest...

Both are great powders but H4350 and IMR 4350 don't work well through the powder measures. As mentioned, set your measure to throw a...

Set your charge lower than intended and use a manual trickler to finish off each measurement. It’s a little slower process but will...

The left side of your stock I think....looks real good....the right side you went too small and too aggressive.....but I suggest you...

your local hardware store will have large pore paint sponges for drywall texturing and other painting sponges as well. Also check a...