Recent content by sable tireur

4/24/2024 Looks like your check will be in tonight's mail. I'll ship brass tomorrow 4/25/2024 Bill

Well done no matter the yardage! I've shot them with .357 Magnums in an auto-pistol between 20-30 yards. Fun stuff! :)

6mm UM (6mm SAUM IMP) :eek:😊

7 MOA is not very impressive at all. Is it possible you meant .7 (point 7) instead? ;)

After extensive testing and load development using the Enduron powders for two years (thousands of rounds), we sold all of it that we had in the shop. We were able to establish better loads and performance using other manufacturers powders. Useless in my opinion. I'm glad other found a way to...

Probably wasn't in Weatherby's wheelhouse at the release. This list was just a small representative selection for an article on the cartridge, not a definitive, all encompassing list. Most manufacturers aren't going to waste a ton money testing every possible combination, the cost of that...

Tough to do. :(

JAM-X doesn't have enough participation to receive PMs. Either post here or get his Phone # for texting. :(

What a cartridge! .270 Weatherby Mag, 6.5-300 Weatherby Mag, .300 Weatherby Mag.

And while that appears to be a reasonable assessment, the fit between the blade and the slot or star is only 1/2 of the problem. The actual fit of the tips into the handle is where the greatest potential for movement comes into play. That's where the fixed blades and the turn screws come into...

When you're choosing general purpose gunsmithing screwdrivers, virtually all of the kits with handles and tips are made in China. Yes folks even the Brownells tips (not the handles) are made in China. All are cheap and fortunately replaceable simply. I have 4 of the Brownells Master kits...

I've used it while loading 100 grain Badlands Super BD-2 and 95 grain Nosler BT. Works great in a 22" barrel. :)

Unfortunately, it pays to check, measure and weigh a selected bullet from each new box. High speed manufacturing and a lack of employees trained to ascertain quality control is the harbinger of potential failure. What would be the response of the manufacturer when you fired a larger bullet in a...

Hawkins has a spacer kit that goes into their long action hunter mags to accommodate short action cartridges loaded to medium length. Unknown munitions has a video showing how it works. https://www.unknownmunitions.com/product/hawkins-precision-dbm-mag-spacer-kit/ :)

A little lighter for detail: