Roughrice's latest activity

Well cleaned the barrel today. It cleaned up pretty easy with BTE. I did notice it felt a little rough in spots. At least when the...

I’ve often started the desire to buy an auto loader in 308 or other more high power rounds than my AR 15. Then I remember my experience...

Build a 6.5 Grendel on an AR-15 platform with at least a 20" bbl. and you'll have a VERY capable wolf / yote rifle. I built mine with a...

Thank you, I’m not sure. I have brass and the bullets are in the mail. I went ahead and ordered powder to play with. When I get...

6 ARC or 6.5 Grendel

Good. Perhaps just slightly low enough on pressure to not lock back. Could still be a slight gas issue. Could be slightly tight lug to...

One last question... Where is the spent brass ejecting? This sometimes gives a clue. 4 O'clock is perfect...3 O'clock is good. 1-2...

Yeah, me thinks it is the rifle...Waiting for the response from Sanders. Will clean it up real well and then shoot a different ammo...

Bent case mouth is probably from ejection. Not to worry about that. That is common when the case is spun out of the ejector port and...

I don't want to be contrary... but I haven't had issues with one piece mounts and have used Aero, Leupold, Burris and American Defense...

I agree with earlier post… shouldn’t be that bad on accuracy. They should replace the factory assembly if it’s has that many issues...

Case head didn't appear to have overpressure. Typical of what I see from most AR types. No super hard ehector print. They did have a...

Typically my grendels have been over gassed and I've added adjustable gas blocks to tune them down......like Roughrice said check gas...

Mine is a 110 BA

That is exactly what I experienced and was explaining in post #8. The ones I experienced were the Ultralight models.