Roughrice's latest activity

I had a hard time with a 16" barrel. Have you tried any factory 168/175 GMM? Mine shot those well. May be a starting point. My 20"...

Yes. 168 FGMM. That was the first ammo I ran thru the rifle. 1.5 MOA @ 2440 fps. I'll load up some Varget and IMR 4064 again but I may...

Yeah... sounding more like a common issue now. My XCR 20", LTR 20", Savage 20" and Waypoint Carbon 20" all shoot great. This CA 16" is...

I think we're getting it narrowed down here.... It's hard to argue with 0.3 MOA results.

Here’s a hot tip. Size your brass correctly AND run a reasonable load and you’ll have less issues. The animal or target won’t know the...

I've not seen that much brass transfer to the bolt face ever. Wow. It could be a brass chemistry issue or as mentioned too hot. That is...

Scope is changed. Will repeat last load data (which is money in everything else) and shoot again tomorrow.

Man, what can I sell to buy that!

Uh Oh... not looking good then. I've read more bad than good about CA rifles and barrels. I was just hoping they got this one...

Good looking rig, my buddy just replaced his barrel. He had the same issue, it got worse when he was running his can. So now, he...

Honestly. Bad barrel. I shoot a 17" MRAD and it's a tack driver with 175's . CA isn't doing so hot when it comes to performance these...

Well just shot another two loads. Same 2" spread. I've been running this Razor LH that was on my old trusty 3/4 MOA 30-06…I'll swap...

I have 125 NBT. My other 20”-24” 308’s handle any weight range of bullet and they are all 10 twist with a couple 11.25 in the 24’s. I’m...

I'd try two bullets lighter weight... Nosler ballistic tip 125's and Hammer hunter 124's If those won't shoot plant some tomatoes with...

I'm looking for information from those who may have a CA 16" 308 carbon fiber barrel. In my attempt to assemble the perfect lightweight...