Rosebud's latest activity

New Christian Arms Messa FFT in 7-08.. RL-15 And 120 B.T.'s.. Rifles only Had 19 Through it.. Last 3 At 100Yds Off Bi-Pod and Bag...

Possible!

Didn't see a direct response to this part of the question so - shoot it again, no need to toss it. Re: length of neck sizing. That's...

I see some people saying it is normal because of the die. Come on. If the die design is normal than we're getting sold a bill of goods

That was my first thought also. Bit of trash in the chamber at the shoulder /neck junction.

1. Could be a speck of dirt or carbon in your chamber. Cleaning it should clear that up. If it’s after sizing, could be too much lube as...

1. Little too much lube. Completely fine and will fire out next shot. 2. Die not screwed in far enough

This is how we reload our Match brass for benchrest shooting, but if you try this on hunting loads, you have to keep the pressure down...

Many years ago, when I was into the “just kiss the shoulder” method, as mentioned, I experienced some that were “TITE” to chamber on a...

Every time I size my brass it gets the same process. The die is set at a 2 thou bump from fired, and the necks get sized back from fired...

I "bump" every time! I load a bit on the warm side and expect the brass to fill the chamber…..maybe it will or maybe it won't shrink...

I use a Forster shoulder bump neck bushing die. Set back 2 ths every time, only the neck and shoulder are moved. Case is form fit to the...

If they start that short and are not expanding into your chamber to be tight you will have head separation problems sooner than later...

Once I set my die to where I want it bumped back I don't change anything unless I lose accuracy. Just went out Saturday with my 308...

Until u go hunting and can't chamber any or very few. I speak from experience when I was very young and had little reloading knowledge...