RockyMtnMT's latest activity

Look at rl15.5 with 75gr HHT. Magic!

Just a side note. When I shoot hammers only in a rifle, copper removal is a snap compared to Barnes, Nosler, Berger and Hornady when I...

Thank you. True we mostly don't need higher BC. But we want it anyway. If one looks at the tailend of the big Badlands thread, you'll...

Brother, you slobbered a bib full right there!

Again, just because you can't do it doesn't mean it shouldn't be done. Also, Barbour Creek isn't "allowing students to take shots like...

His Rifle is a Stainless Remington action, McGowen 30 " 1/10 twist spiral fluted Sendero barrel with a 5 port Terminator brake . It...

Yupp. I have a 214 Hammer going over 3100 FPS in my 8 twist 300 RUM.

They have done a good job managing their herd.

I drove through there last May on my way to Idaho and saw several Pronghorns, including a couple of bucks that looked like they had a...

Good morning! We are. We have several prototypes in 224, 257, 264, and 284 that are pretty much done. They are showing a form factor...

I am using a 338 Sherman (338-06 improvedish) with a 22" barrel. I am using a 190 mono at 2950ish. It has been used on WT with a 175gr...

A 108gr .257 cal bullet with a g7 bc of .283 would require a form factor of .83. That is simply amazing! I think the best form factor...

Yep. I ran the 124s in a Kimber 30-06 over all the varget it would hold at 3450. It was a point blank beanfield rifle for me...

Each Hammer bullet is listed with a minimum required twist for proper terminal performance. The minimum twist rate is much more about...

Fruit nut, I have a load in my 300RUM shooting a 154HHT @ 3895 fps (26” barrel”, have not put it in an animal yet, but it hammers steel...