Rflshootr's latest activity

Nawwww....the load was outta tune 🤣

IBTL

Check the tip of the firing pin to make sure it hasn't actually chipped or sheared off? Or no debris is in the bolt body, causing the...

Have you blanked a primer(s) previously? If you have, disassemble the bolt again, and spray the inside of the bolt body with some...

I don't buy it, or any brass for that matter that says Hornady.

Peterson brass is thicker, meaning less case capacity. Less case capacity w. same powder charge = more pressure = more velocity. Also...

Keep in mind that most barrel blanks come 28" long and will finish at 27" after taking 1" off the muzzle. If that extra inch doesn't...

Here are some numbers that I ran on Bergers calculator for a Speer 150 grain boat tail. I was conservative on velocity at 2650 fps at...

My 155gr AMAX load is IMR3031 with WLR. Great velocity & precision out 18".

Looks about right. Maybe a bit shy on primers.

100 yard 7 shot group from the 20". Yellow square is 1”

I would recommend, unless you are shooting very long distances, to switch over to a good 150 grain bullet and push it with IMR 3031...

You have to take into account that every barrel is different. Secondly, different lots of powder are different, different lots and...

Very nice! I used sponges on my Savage Striker as well.

Check with CH Tool & Die. Page #10 on their site. You may have to send them a couple of fired cases to be sure. $116/set. Not a bad...