Rflshootr's latest activity
-
I finally got to shoot some more today. Shot 2 10 round groups of the same charge weights 67.5gr h1000 one with white river LRP and one... -
If I had a 6.5 for deer, I'd load a Hornady or Speer soft point.
-
6.5 NeedMore...
-
Rflshootr reacted to Clem Bronkoski's post in the thread Do you have to resize brass if you never fire and pull the bullet? with
Like.
Just back out the decapping pin and run the case thru the die -
Rflshootr reacted to Rick Richard's post in the thread Do you have to resize brass if you never fire and pull the bullet? with Like.
It’s all about CONSISTENCY. Can’t expect ultimate results if not ALL are loaded with the same process steps.
-
Rflshootr replied to the thread Do you have to resize brass if you never fire and pull the bullet?.Just remove the decapping pin and resize them. That way you'll know everything is good to go. A few rounds won't take that long to do...
-
Rflshootr replied to the thread .008 Bump Required to Smoothly Chamber Round??.All that brings a question to mind. If you have fired 1500 rounds through the rifle and it was ok until now, what changed when you...
-
Rflshootr reacted to Dean2's post in the thread .008 Bump Required to Smoothly Chamber Round?? with Like.
His fired brass, prior to resizing of any kind, are hard to chamber when put back into the rifle. That should NEVER be the situation...
-
The cheap ones work but for how long ? Run a high end scope then go run a lower end and you'll know why they are lower end. The guys...
-
Rflshootr replied to the thread .008 Bump Required to Smoothly Chamber Round??.I'd call or email Hornady and tell them the problem. Tell them the sizing die isn't sizing enough at the base. You may have to send the...
-
Well there ya go!! Nice work boss.
-
Rflshootr replied to the thread Modify custom action ?.Good job! You went the best way you had access to. Hand tools are a bit slower, but you have much more control as you go as opposed to...
-
End of story: First, thank you Elk Hunter 338 for your offer to professionally mill the rail and refinish the metal work properly...
-
That is what I was refering to. Being on oxy for an injury and posting is not a good practice, things get all mixed up in my mind. Sorry!
-
It was cut by McMillan for the heavy wider defiance handle