Rflshootr's latest activity
-
Took me a minute to figure the photo thing out -
Rflshootr reacted to Brathany's post in the thread Weather & Elevation vs consistent load HELP with
Like.
Electrical tape has even found uses in the modeling industry. You should Google, "The Black Tape Project", and I advise researching alone... -
Rflshootr replied to the thread Lee dies...what am I doing wrong???.Also try a slightly bigger chamfer inside the case mouth.
-
Rflshootr replied to the thread New Chronograph Out.I haven't had the opportunity to use a Garmin, but the Caldwell seemed a bit slow in getting its reading and the screen seems small for...
-
Cats ain’t bad if ya marinate ‘em long enough.😂
-
Got really lucky as a non-resident to draw one of the two NR Muzzleloader Elk tags in a top tier unit. With the rut just ending, the...
-
I have an inside action wrench for tikka and a short action customs barrel vise…torqued to 100
-
Rflshootr replied to the thread 7prc headspace issue?.How did you tighten the barrel and how tight did you make it?
-
Rflshootr replied to the thread Iron sight plugs.https://jaoutdoors.com/product/remington-receiver-sight-plug-screw/ pack of 4--$10
-
After wasting a few hours trying to do this cleanly, I’m with you. Just gonna buy the stupid screws 😂
-
Rflshootr replied to the thread Iron sight plugs.Just buy the screws!
-
Rflshootr replied to the thread New to reloading.No. Typically it is because of multiple firings unless there is a burr around the ejector hole on the bolt face.
-
Too low and forward. Aim about center of the shoulder front to back and just above center uo and down. They will fall where they stand...
-
Exactly what I thought too Too low and forward
-
Rflshootr replied to the thread New to reloading.In the pic of the Hornady brass, I see multiple ejector marks on the middle and right cases. Just saying.