Recent content by redleg1013

Bob Ackley and he handles the heavies just fine.

Happens more than than a body would think, and it doesn't go down the rifling, thus the KB.

That's pretty much where I stop load development and will practice shooting at the distances I plan on harvesting from.

Tag

Easy, 30-06

You sure you have the primers completely seated? My shooting partner had this issue when starting out, as near as we could figure the "light strike" finished seating the primer and the subsequent strike would actually crush the anvil. Even with "good brass" I still uniform and square up the...

Glenfield model 60, I figured, as a kid, that since it had a squirrel on it that indicated what it was for... c'mon I was nine.

Tag

I had a RockChucker that wasn't made here, and I could watch the top of the press flex while using it, I put an indicator on it and the ram would deviate almost .015 (because of the flex). I switched over to a Co-Ax B2 (I believe they are on revision B5 now) about ten years ago and have never...

300 WSM

It didn't work so well in Kansas. NFA revenues are a massive cash cow for a dept that would otherwise be unmanageable with debt -- they will NEVER give it up, especially since nobody, not even our precious NRA, has successfully challenged the NFA in almost 100 years.

EPA shut them (Hurculeaneum) down under Obama with their crushing regulations. A lot of bullet manufacturers went along with the canned line of using imported recycled lead from Australia and Asian Rim to assuage fears and prevent panic buying... gee Australia is a growing dystopia, and the...

This is where you need a lawyer, an actual went to school and passed the Bar Exam lawyer, not some keyboard attorney, or Legal Zoom. I used to work in a gun shop as a kid and the owner, on top of tax evasion, got smacked for essentially practicing law without a license, for redistribution of a...

I got a chamber length gage and then trim more for uniformity say .003 for the target rifle and .005 for hunting rig. Newer chamberings with steeper shoulders tend to not grow as much as my '06, and typically need less work.

Are you Mark?