QuietTexan's latest activity

Is this not America? Are we not allowed to voice our opinions on a public forum on a thread where opinions are solicited? To you I'd say...

So go somewhere other than the SUPPRESSOR sub-forum 🤣 It's like going to a Chevy forum and calling them all straight, it's gonna...

Could throw a huge wrinkle in and ask about the balance used to obtain this volume via mass-by-weight-proxy information. 🤣 The rabbit...

Side note, any opinions on Blackhorn 209 in an Ultimate? Manufacturer says bad juju, but they also say that about handloads in regular...

Finally have all the pieces in one place. Rem 700 LSS Ultimate with an NF NXS Primed brass Hammer Bullets MMP Sabots Alliant Blue...

I load the 180HH for son's 30-06 700ADL 22" barrel and is stupid accurate as factory rifle. Load maxed out around 2925 W760 so 4" extra...

If you did this with RL26 and Hammer bullets in a 6.5 Creedmoor you might tear the space-time continuum 😈

Well speak of the devil!!!!!! Got these today on one of my cameras at the ranch! First birds I have seen on camera, and we have 8 total...

This is correct I run SAC dies on my 6 Dasher and I have the Redding Bushing die set for my 6.5 CM. I run a separate Erik Cortina...

The reason why the turkeys and quail have gone down 90% in my area is due to the feral hogs. 35 years ago, had herds of turkey of almost...

For sure! The more nesting cover turkeys have, the better the hatches will be.

I agree. I get that not everyone can have multiple cans, but if I'm lining up multiple rifles to be shot they'll all have whatever they...

1. Could be a speck of dirt or carbon in your chamber. Cleaning it should clear that up. If it’s after sizing, could be too much lube as...

Didn't see a direct response to this part of the question so - shoot it again, no need to toss it. Re: length of neck sizing. That's...

Most all S dyes leave about a 1/16”- 3/32” of unsized neck. That’s with the collar adjusted to hear a very faint click of the bushing...