quandary's latest activity

I have not used Peterson prc but have in other cartridges and it seems like good brass. No issues. I have gunwerks, adg, and lapau. All...

I look at it as the cost of Proof/Bartlien/Benchmark carbon barrel. On top of that it is used more than any one barrel. Put in that...

I think you would do well to consider the Redding T-7 press as a lower cost alternative to the Area 419 press. A turret press cuts...

I should note that RCBS replaced their sub and the parts supposedly no longer have this issue.

I have the Summit press. I have broken twice sizing PRC brass. Once the handle sheared off, the second time the top yoke between the...

I have Peterson, Lapua and Norma brass in various cartridges. I like my Peterson brass the best. To me it is the highest quality of what...

Took me a minute to figure the photo thing out

I got this great bull on day 5 of Colorado second season at a little over 200 yards with my 8mm Rem Mag. I did a fair amount of hiking...

Another question. Is there a favored? powder for the 35 Whelen?

Seems like The Redding die sets for the 35 Whelen Improved out of the Series D Die Sets is the best option?

Yes it is! When I form cases for my .373 AI, I use BMG powder……I have a lot of it! It's waaaay too slow for the available case...

You'll 100% need to fire form brass to get full AI capacity and profile. As mentioned by others, your first 100-200 rounds down the new...

The only reason not to go AI would be because the dies are more expensive. Some say they have a harder time feeding AI cartridges, but...

P.O. Ackley was way ahead of his time! His design has so many benefits; longer caselife, less bolt push back, better velocities, very...

Yes, you can. Load it with 35 whelen data, not ai data when forming. I load for 243ai, 250ai, 257ai, 6mm rem ai, 280ai, 7x57ai and all...