PatriotHenry's latest activity

Here is the replacement 22" 1-8 Benchmark fluted barrel 6.5 PRC Chambered by @Fisher T&C using a Alpha reamer. Turn around time was...

From the pictures, Looks like the spring may have been put in the magazine backwards, Or spring was not bent correct, in the folds...

This is a simple fix and we have since zero'd in on this issue. We had a batch of new springs that were overly compressed from our...

Gunsmith here too. You shouldn't fool with the feed lips on Hawkins mags. They recommend disassembling the magazine and adjusting the...

Gunsmith here, you need to play with your follower and spring. Once it’s in the correct position you need to stake it with a punch and...

100% a mag issue. Fix or replace the mag and ensure the bullet tip is angled up towards the feed ramp and it should feed the cartridge...

I had a similar problem with a Hawkins Hunter DBM in short mag. Upon inspection I found that the follower had a piece chipped off it so...

This!

I agree with the spring tension that was mentioned, however, your first call should be to Hawkins and see what they tell you to try...

If I understand where you are putting the washers, it’s making things worse. If anything, I think you want to move the BM closer to the...

Your pure precision stock …..what was the bottom inlet cut for? A lot of them are cut bdl. Did you order it to be a m5 cut? Also...

Hard to say without the gun in hand but… If you look at the 2nd photo, you can see that the cartridge does not contact the feed lips...

MAKE OFFER!

bump

Cleaning off reloading bench For sale: SOLD-TT Primary LH R700 trigger silver curved shoe less than 50 rds fired with it $140 shipped...