Recent content by oneeyedmac

  1. O

    savage 200 convert center feed mag to stagered feed

    This is a Savage bolt head: The round hole in the middle of the bolt face is the firing pin hole. The small wedge shaped piece at the bottom of the bolt face is the extractor, it goes over the rim of the cartridge and pulls it out of the chamber when you open the bolt after firing. The...
  2. O

    savage 200 convert center feed mag to stagered feed

    You'll have to have the bottom of the newer receiver milled for the slot that attaches the old style magazine to the receiver. It's not really practical. You need to check to be sure the ejector is operating properly. It sounds like the case is being extracted from the chamber OK but then...
  3. O

    Weatherproof Gun- Stainless of Cerakote CM

    Krieger says not to use Stainless Steel in extreme cold. Have you thought about Black Nitride? That will not only make it weatherproof, it'll make it scratch proof and tripple the life of the barrel. The treat the whole barrel, including the bore. Google H&M, they are in Ohio and do a nice job.
  4. O

    Model 12 lrpv bolt heads

    I didn't even know Savage had a controlled round feed. Anyhow, I think you are looking for Savage part number 103960 or 100094. Brownells has them in stock for $22, here is a link: SAVAGE : Bolt Head, Magnum, Right Hand (855-000-003) - World's Largest Supplier of Firearm Accessories, Gun Parts...
  5. O

    Decision between two stocks... Need help.

    If you want to take the wood grain texture out of a laminate stock Duracoat makes a product called durafill that works well. I've used in on a Taurus 1911 to take the billboard advertising off the slide and it was great. I think it's similar to spray on polyester fill that the car guys use, but...
  6. O

    Hang fires, Jewel trigger of firing pin???

    I've seen this before with a Jewell. If there is anything between the cocking piece of the bolt or the sear of the trigger this can happen, at least that was what caused it in our case. Make sure the safety of the trigger isn't contacting any part of the stock too, they are bigger than a factory...
  7. O

    Final assembly.

    The fit and finish is unreal on that rifle. Incredible work.
  8. O

    $2,500 Outfitted Antelope or Black Bear Hunt Giveaway Contest - Redbone Outfitters

    Re: $2,500 Outfitted Antelope or Black Bear Hunt Giveaway Contest - Redbone Outfitter "Enter Me In The Redbone Outfitting Contest".
  9. O

    Free Nightforce NXS 3.5-15x56 Scope - Drawing

    ---------------------------- What state(s) do you hunt big game in most often? Ohio What is your primary long range hunting cartridge? 12 guage, no rifle hunting deer in Ohio -------------------------------------- Regarding your primary long range hunting cartridge choice above: Do you use...
  10. O

    stock textured grip?

    Hi guys, brand new here. I've seen this question asked and answered on a tactical forum. I hope it's OK to post a link to that thread. The way it's done is with stock bedding material stipled with a plastic bag and then the shap edged sanded off. It works extremely well. Here is the link...
Top