Old Rooster's latest activity
-
OOld Rooster replied to the thread Colorado wolves being relocated..These people are highly educated! There is an old saying, "Some people are educated beyond their intelligence". I think this fits!
-
OSo, lets see... they killed cattle in Oregon so lets move them to Colorado. Whaaat? They killed cattle in Colorado, too? That's...
-
OOld Rooster reacted to huntinfool18's post in the thread Colorado wolves being relocated. with
Like.
Bring on up to Wyoming. We will take care of them for you. -
OOld Rooster reacted to lancetkenyon's post in the thread Colorado wolves being relocated. with Like.
SSS
-
OAnd they go on to say we need more funding. Yes give us more money to screw you over in a new area typical government crap!
-
OHe just said they are a problem now we will move the problem elsewhere to continue the problem. ***!!
-
OSSS
-
OOld Rooster reacted to crashlanding's post in the thread Colorado wolves being relocated. with Like.
And the survival rate for re located wolves is poor, maybe a win for us
-
OMy lone set of Talley's are anodized. I lapped them because they were badly out of alignment and would have marked the scope had I...
-
OOld Rooster reacted to MostlyUselessLurker's post in the thread Recommend 20moa ringmounts with Like.
The ones he linked are aluminum.
-
OSome great suggestions here. I have been exceptionally happy with my Badger USMC rings and 20 moa rail on my Remington 700 SA. I've...
-
OI appreciate the information and advice. My case and situation is a bit complicated. My doctor will not do a block beforehand. I do...
-
OOld Rooster reacted to Rick Richard's post in the thread Do you have to resize brass if you never fire and pull the bullet? with Like.
It’s all about CONSISTENCY. Can’t expect ultimate results if not ALL are loaded with the same process steps.
-
OOld Rooster reacted to Varmint Hunter's post in the thread Do you have to resize brass if you never fire and pull the bullet? with Like.
You could just reseat the bullets, but the neck tension will be lower. You could then use them for barrel fouling loads and you're good...
-
OOld Rooster reacted to Roughrice's post in the thread Do you have to resize brass if you never fire and pull the bullet? with Like.
I just neck size those to get the neck tension back.