Mikecr's latest activity

Didn't see a direct response to this part of the question so - shoot it again, no need to toss it. Re: length of neck sizing. That's...

When using bushing type dies the bushing doesn't resize all the way down to the neck-shoulder junction.

For thickness (of different brands) I would measure mid-necks, and web thickness. I'm just suggesting that this could be difficult to...

Then ask for thickness of it. But good luck finding someone to determine that for you. Volume of new brass is an abstract, with every...

The volume becomes what it does locally (from YOUR chamber).

I agree, but it’s shooting .5 MOA! 😳 But since I just completed a successful elk hunt, I may go ahead with adding freebore. Got room in...

Tell him to separate the gun (incl scope) into a couple dumpsters and be done with that mess.

MOA, I wouldn't allow bullet bearing through the neck-shoulder junction. It's no problem for a gunsmith to make adequate room, and I...

Seems like you're considering this from a load density perspective. Lower load density causing lower velocity higher load density...

Thanks. I know bore, groove/, barrel profile/contour, alloy can be different, and that calibration is in order. I am doing similar with...

My one bullet guns list goes like this. My custom Ruger M77 MK II 25-06, 110g Accubonds, used for everything, varmints, deer, pigs &...

I use 1 bullet per gun

While Pressure Trace shows a burn's form, unless using an official test barrel (SAAMI), the hard numbers could be as wrong as QuickLoad...

No matter the source of reloading info, powders vary by lot. At least with QL you can calibrate your local powder lot, per the charge...

I can't say it like Darkker, but there are some crazy-wild selections in QL. Things that could get you in a mess. So the golden rules of...