Mikecr's latest activity

The volume becomes what it does locally (from YOUR chamber).

I agree, but it’s shooting .5 MOA! 😳 But since I just completed a successful elk hunt, I may go ahead with adding freebore. Got room in...

Tell him to separate the gun (incl scope) into a couple dumpsters and be done with that mess.

MOA, I wouldn't allow bullet bearing through the neck-shoulder junction. It's no problem for a gunsmith to make adequate room, and I...

Seems like you're considering this from a load density perspective. Lower load density causing lower velocity higher load density...

Thanks. I know bore, groove/, barrel profile/contour, alloy can be different, and that calibration is in order. I am doing similar with...

My one bullet guns list goes like this. My custom Ruger M77 MK II 25-06, 110g Accubonds, used for everything, varmints, deer, pigs &...

I use 1 bullet per gun

While Pressure Trace shows a burn's form, unless using an official test barrel (SAAMI), the hard numbers could be as wrong as QuickLoad...

No matter the source of reloading info, powders vary by lot. At least with QL you can calibrate your local powder lot, per the charge...

I can't say it like Darkker, but there are some crazy-wild selections in QL. Things that could get you in a mess. So the golden rules of...

Like Mrvmax, I always run my loads through QL. In my hunting rifles, I shoot mostly machined-copper bullets for which there's no...

I was an early adopter of QL I don't know how **** long ago, and always loved it. To be good with it there are things to learn and...

I accept 12-13thou, and turn necks to and within this range. Here I get reasonable tension with low variance. That's just me. I turn...

I would not like necks so thick, either 14thou for Barnes, nor over 15thou for Lapua. And the barrel finisher should have engraved...