Mikecr's latest activity

If only dogs were that smart

I do full seating testing with exception of touching (ITL) (I don't go that far). Normally starting ~5thou off the lands (OTL) working...

I believe that optimum seating is an abstract, unpredictable, and changing with different chambers even with same bullets. The reason, I...

Same as any other. Seating tests also do not have to be taken to lands. We don't even have to know where the lands are.

With VLD Hunting bullets, in my hunting rifle, seating g depth mattered huge. Jam= 1.75 moa .01 off= 1.75 moa .02 off =1.25 moa .03 off...

That's only with use of moly, and not due to reduced friction. Moly cools the charge while evaporating. This lowers MV per charge, and...

Which chrono? Some are passive and see a dip in light, some are active to cause a reflection

You should be ok, but I don't know how old your reloaded ammo is. Full spring back occurs over time, so your ammo could get tighter...

Your rifles chamber is the only case gauge you’ll ever need and the only one that counts. It takes a few firings for brass to stop...

I should think it would be rather impossible to determine a .0002-.0005" seating depth variance effect on precision. Considering the...

The apparent non-response to this problem from reloading companies seems unbelievable to me. If I had a reloading company, I would just...

The tightest CBTO window I've had so far, as tested with group shooting, is 8thou. I seat in the middle of window and keep my CBTO...

For consistent CBTO, it helps to pre-qualify the ogive datums. There is a tool referred to as a Bob Green Comparator (BGC), that does...

I agree with MagnumMania on matching the chamber reamer to the BRASS in-hand, for the clearances you desire. I do this and after full...

Your post reaks of the worst type of internet challenges. The petulence of someone who has added nothing to the accumulated knowledge...