memtb's latest activity

So when do we get to annealing primed brass? 🤣

Why wouldn't that work? So if you run it through the grinder do you get 2400 ? Chop the 4831 in half? Technically I suppose it would be...

Kind of along the same lines as using a electric coffee grinder to make 4831 short cut powder out of standard 4831...

I just stop the tumbler/vibrator with enough media in the bottom that they aren't all clanking together. I've measured CBTO after...

Unless I missed where you called me a low down dirty democrat, I am not offended. LOL! Just wanted to set straight the record. You made...

OP, when you say "Tumbling", are you talking just throwing loaded rounds in a rotary tumbler (like a rock tumbler or wet tumbler) with...

Brathany, first I think you have taken offense to my post, it was not meant to be offensive to anyone including you. My only intention...

Just remember when you’re doing this method always tumble in 90 percent alcohol. 😉

If you did this with RL26 and Hammer bullets in a 6.5 Creedmoor you might tear the space-time continuum 😈

So that’s how you make flash powder??😁

A lot of things can happen in 1.6 seconds…..many of them bad! memtb

1.6 or so I'd guess..............maybe:)

Like everything in life, never trust but verify

Have not hunted out of state for 15 years. Pulled the camper three hours south to fill my antelope tag , two hours east to try to fill...

I have done it before, but decent hunting starts 2 hours drive or so from my house--- so if i wanted to have boots on ground and walk...