M1A1ABRAMS's latest activity

I totally agree. The only reason I bought a Creedmore was that it was available in the AR 10. For my purposes it works well but it's...

Quote: I believe the only reason for the introduction of the 7mag and 300 mag. Was that they didn't have range finders back then and it...

I believe the only reason for the introduction of the 7mag and 300 mag. Was that they didn't have range finders back then and it was a...

Nice placement! Entrance or exit, range, cartridge. I looked the rifle specs up……looks like a nice pkg. memtb

1/2 moa…… you just reduced my maximum range and perhaps even changed my preferred cartridge ! 😉 memtb

Thanks for sharing this. I hope that it is going to shoot fine now.

my smith in co springs is awesome semi retired though, there are quite a few hacks around the front range

put it back together with the recoil lug actually doing it's job properly, you've got good odds it's back to shooting. confirm that was...

@SkunkedAgain I see you are in Sedalia, CO. Just 6 hours south of you is one of the best, most trustworthy gunsmiths you'll find -...

If it were me... At this point, reassemble. Reinstall scope. Shoot it as recommended 5 rounds without any devices on the end of the...

Wouldn't hurt to shoot 5 Rds before sending it back. Long wait especially if you already found the problem.....just me

First time using this gunsmith. I had a 30-30 that was jamming on me a few years ago and I took it to two different gunsmiths to fix...

Not all GS are good. I am fortunate to have one of the best 35 min from my house and he is a sponsor on this site and builds some of...

I use an old fashioned Q-tip on the crown. Slide it in and out all around the bore to see if any fibers are pulled off by burrs or...

Is this the first time you've used this gunsmith? I am fortunate to have access to a reputable GS within an hour's drive. I have been...