Recent content by leagle77

Andy, this is a long shot (pun intended) but do you have, or know of a source for, TAC 15 i (not Elite) parts. I have a 15i that has a broken pawl (I think that is what it is called. The piece that clicks in the ratchet) It isn't in pieces but cracked and the end hanging off. If worse comes to...

Twanger, thanks for the assist. Just a little prying with a small screwdriver. PRS completely installed. Got some Aero Bolt II inbound as well as a spyderweb target. Found out that my old block was no match for 405 fps. thanks again

Twanger, thanks for the quick response. The plate is on the Elite. I was under the impression that the plate should just "fall" off as well. I'm such a klutz that I was afraid to do anything to it w/o asking advice. When I get home I'll gently try prying. I really hope this works because I need...

Twanger, I have a Magpul PRS that I want to put on my new Elite. I can get the castle nut off but I can't figure out how to get the plate off. Any advice would be appreciated . Thanks

I heard back from Dorge. They indicate to use the standard Aerobolt II 200 26". Hope this helps any other newbie.

I am trying to replace the stock on an Elite. (I'm trying to replace it with a Magpul PRS) I've got the "castle" nut loose but can't figure out how to get the thin locking nut loose. Thanks for any help.

I have a new Tac 15 Elite in bound. It will be set up with the drop away rest and Timney trigger. I will be hunting whitetail. What FireNock will it use? Finally, has anyone tried the new Toxic broadheads with the Tac? Thanks for any information

If it is too good to be true....... Seems like there have been several Python ads here and else wear that didn't pass the smell test.

Anyone running one of these on their Tac 15i? The thing is huge (2.2 lbs) and the height certainly isn't condusive to a good cheek weld but the opportunity to program it with recticles of your own design is very interesting. You literally can program the reticle to your particular weapon. No...

WW, thanks for the ideas. I hadn't thought about suspending the yellow jacket target and I didn't realize that the nock was moveable. I live in Sussex County, De and the solo cup factory was over in Federalsburg, Md. The bales were in such demand by archers that there was a waiting list for...

I have some really basic questions that didn't seem to be addressed elsewhere in the forum. I'm new to crossbows but have some experience setting up compund bows. Because the nock point is "fixed" on my TAC15i, am I correct in assuming that all paper tuning adjustments are done with the rest...

I think that your problem is addresses in a post couple down http://www.longrangehunting.com/forums/f108/hha-vertical-asjustment-78628/ I believe that the solution applies regardless of whether you are running the HHA or not.Hope this helps.

Thanks for the reply. I'm going to contact the guy and reverse the trade. i like to tinker too much to be handicapped <g>

Just made a straight up trade for a NIB TAC 15 (or so I thought) Did it over the internet so sight unseen. Instead of a TAC 15 the guy had a 15i. I already had a RRA lower and Magpul PRS and was set to order a Timney trigger. Before I send it back (unopened) is the 15i customizable? Can I...

Enter Me In the US Optics Rifle Scope Contest