lancetkenyon's latest activity

I'm wondering how fast a Berger Hybrid can be launched with predictable results.? Barrel life isn't a real concern for me either. But...

With 40° shoulders, I say do it in 3 steps when necking down .020" (.273" to .253" +/-) like .266, .259, .253. I do that from 7mm to...

Just a word on new brass and neck condition. I run all new brass through a custom neck die and then through a mandrel before doing any...

+1 Even if you consider that the starting pressure in the case is 14.7 PSIA, and you are squeezing the volume of the mandrel down into...

I haven’t decided to use them for hunting, but I know that the A-tips are stupidly accurate and consistent in my 6CM PRS rig 4.6SD-...

If they work for one caliber we'll, I would suspect they'd work just as well in another. I cant speak for the .257 but I can on 6.5 and...

At the encouragement of a man who hunts for a living I used A-Tips in my 6.5 SAUM @3000 fps on my last deer hunt. At 300 yards a large...

I'll see if I can locate some and let you know.

Run them through the expanding mandrel. Primed or unprimed. No difference. I have done 10s of thousands each way. NEXT time, run...

You should be fine either before or after priming. The air is a compressible fluid so no worries on pressure from inserting a mandrel...

The Garmin chronographs measured to the 10th

The wild card is always powder and bullet used. Either one can influence barrel cleaning frequency. Copper reducing powders, mono's...

I did the build. My reamer is from JGS

Thanks a lot...you just cost me about $7k... Did Axisworks build this with Charlie's reamer?

Not a typo.