Kmccord's latest activity

I had thought, Kelbly sold proof pre-fit barrels for there actions, have you contacted Ian?

You should contact Wyatt, they will assist and point you in the correct direction. I have three I built using Wyatt's Extended Mag...

Remington 700 rifles are inherently accurate and shoot sub moa without any problems. There are however problems that do crop up and...

sorry, I am a bit late to this party. Here is the load that I was able to develop for my 6.5 PRC hunting rifle using the 124 grain...

Try leaving the barrel for 50-75 Rds. Everytime you clean it requires X number of rounds to re-foul the barrel to get back your...

I would not do a large frame ar for coyote. With a $1000 budget you won’t get there. Large frame ar’s can have issues with parts...

Large frame rifles tend to be a little more finicky than small frame rifles, I’ve built a dozen small frame and 4 large frame. No...

Let's see a picture of the rifle.

I forgot to mention allow you barrel to cool between shots, (i wait 5 minutes) thinner barrels tend to “walk” when heated up especially...

I've seen on this forum that occasionally the mag box and bottom metal may have been installed incorrectly. Additionally your torque on...

Yes, the trimmer is powered. The same motor powers all processes and is on as soon as it is powered. Check out at the ~11:00-minute mark...

LOL, I do look kinda goofy while doing the case work, wife says I look like a seamstress with the foot pedal thing.

What did you find?

I had a custom 300 PRC built that wouldn't shoot smaller than an inch and a half no matter what. I swapped out the scope, scope rings...