ka30270's latest activity

Keep an eye on unknown munitions in Northern Idaho. They have mentioned it a couple times. Also they recently purchased a 3D printer...

Had a biuld done on Tikka for the first time this year. 6-7PRC I've always used Remington 700 actions. I'm sold on the simplicity of...

The heck you say! Looking forward to that, I hope the tolerances are as tight. As far as I know Tikka is the only factory action where...

I got me 1 of them!

One of my favorites....

Okay I removed and examined the spent primers. Correct me if I’m wrong but I’m not seeing excessive pressure compared to the new unfired...

That makes more sense to me and is how I have understood the pressure curve. When you get closer to the lands pressure goes up but...

I had the same issue with some 44 mag loads the other day flat primers and a little sticky extraction coming down 1/2 to 1 full grain...

Yep, that is over pressured. Start to reduce that load

Is the face of that plunger square? Looks to me like a machining tit left behind in the middle, but your pic is blurry. I have had...

I agree those primers are showing pressure. Or at least appear to be.

Lower the charge on a couple and see if you get the same swipe. Those will tell u if it's a mechanical issue such as ejector with junk...

The primers look like they are pretty darn flat. If you push out a primer take a close look at it to see if there is still a little...

Doesn't exactly look like classic ejector swipe. Use a punch and check to make sure the ejector can be pushed flush or slightly below...