Recent content by joelpend

SOLD

Possibly if heavier contour in 22, 6 or 6.5.

Just purchased from Bugholes recently. Indicated in and took the small cut shown on the chamber end. The dia. of the machined area is 1.087" and the length of cut is .715". Additional material would be removed to fit to any actions that are 1.062" tenon. This is a .300 bore .308 groove 5R...

No need to use a buffer detent and spring with a JP Silent Captured Spring.

Yes

Price Reduced

Included, Lab Radar in Excellent Condition, Lightly Used LR Bench Top Mounting Plate w/ upgraded Manfrotto QD Ball Head (Original LR ball head is junk IMO) 10,400 MAH Lithium Power Bank LR Microphone Trigger Accessory Sandisk 32GB Memory Card Very Nice Calvin Klein Soft Case Cable to Connect to...

A few years ago AA1680 was considered the magic dust for 300BO heavy bullet subsonic loads.

If you in fact need one, I recommend using it every firing. If the bulge builds to a certain point then the collet will not slide over the bulge to size it down. I dislike belted cases and do not currently own any. Still have the Willis die, maybe time to sell to someone needing one.

Those projectiles are terrible for any type accuracy. Most FMJ bullets will not consistently produce accuracy. FMJ are usually the cheapest bullets you can buy.

Agree, as the referenced article covers the advantages of modern case design. Helps with factory ammo, reloads by experienced persons not so much. I have seen some really good shooting 7RM. No personal experience with 7 PRC yet.

Respectfully, this is not correct. You have freebore diameter, freebore length and throat angle when talking chambers. The freebore diameter is virtually the same on both and the 3 deg throat on the RM is steeper than 1 1/2 deg on the PRC which means the bullet ogive will touch sooner. The...

One solution could be to add a 20moa rail backwards on top of your rail. This would yield 0 moa. Would need short rings to keep scope low. I have a couple of these, I think one is made by Badger.

I had this exact issue with WLR a few years back. Turned me off of Winchester primers, will never use them again for anything except maybe a low pressure cartridge. Messed up a couple of my bolt faces just like yours. I used thousands of them when they were plated and never had a issue until...

I have been reloading for 50 years, making cases, wildcats more in early days than anything else. I have seen this often. It is happening in the sizing process. It is most notable when you are sizing several thousands like you are here. I see it when making cases not normally when reloading...