HandgunHTR's latest activity

It was in the video, which has since been taken down.

Where were the entrances and exits, exactly, on the deer? Pictures would be best. If the hits were above mid-body, the fact that the...

What did it look like on the inside?

Either of your choices are going to require work to the trigger, unless you actually like a two-stage trigger, then the edge goes to the...

Exactly. Every unit of measure we use is made up.

Congrats on a beauty of a bull. I have 6 points in WY, so I am going to start applying next year. I will have to check out Skyline.

I use mandrels with some of my standard FL sizing dies and no expander at all with my bushing dies. It takes a bit of experimentation...

I will also add that the powders that work good for heavy bullets in the .223 will work with the 6X45. The GameChanger bullets may be a...

I have a PDF with a lot of 6X45 loads in it. Not sure where it is from anymore, but I got my hands on it a few years back when I built...

Just wanted to add that it isn't just the shoulders that grow. The web of the cartridge will expand to fit your chamber as well and...

Just placed an order with Midsouth Shooters Supply that included 100 pieces of Hornady 25-06 brass that I will be using in a 6.5-06AI...

Yep. Never shoot the donor unless you plan on buying a new donor.

TTT

What about the 300SS? You may run out of mag length with the WSM using the heavy bullets, but you shouldn't with the SS. This guy...

I should qualify that I tend to shoot smaller cartridges with a suppressor so spotting my shots through the scope and not having to wear...