eshell's latest activity

I don't post a ton here nor have been a member very long but I can say of the various internet forums I have "hung out" on, this is the...

I used Badger M5 bottom metal for AICS mags on an M700 SA DM in a .308 rebarrelled to .243 and it worked fine with real AICS mags.

@kanab ram : What radio service was the online test for? Was there a fee? I asked this above but it was buried in a long post and I'm...

I recently bought two scopes from @Elkbelter, one a Leupold MK4 4.5-14x50 mildot advertised here...

Man, some of the worst shooters I’ve met were ex military, police, and “swat” guys. That credential doesn’t give you a bit of credit...

Sounds like the screws from your scope mount might be too long and are intruding into the action. What type of scope mount are you...

She looks a lot happier than that fella with her in the deer pic.

Just be careful about approaching max pressures and creating sticky extraction. The 788s have had the bolt handle welds break loose as a...

Agreed, sounds like it's not locked up when a cartridge is present, possibly due to not be sizing sufficiently. May also be due to the...

Sounds to me you are not getting full engagement of your barrels locking lugs. I would first Try bumping the shoulder of your brass back...

What "area"? What's "LR"? Some long distance ranges that come to mind are listed below. Note that some have a daily fee, some are...

I'd call Mack Bros. They may have a 0 moa base if that is what you prefer. Check the screw spacing and see what round action matches it...

Could it be a Rem 700 base on a round action? If it was made for an action with step in the top of the receiver and put on a round...

I think you guys are going to need tickets to Nigeria to see these in person.

Set your charge lower than intended and use a manual trickler to finish off each measurement. It’s a little slower process but will...