cjens's latest activity

I run a 28in 338 edge with a Lane suppressor..it is very long but not to long to haul into the woods..running 270grn eldx at 2980fps...

Well, I have zero experience with suppressors, but a REM 700 running an Edge and a brake I do. I ran a 32” barrel to start, no taper at...

Agreed. For me, it’s too top heavy to even stalk in open country for Antelope. I’ll give up a few 100 fps and just learn the dope...

I be been thinking about doing a 338 edge as well but im looking at Defiance actions and was thinking about 26 inch tune , Mabye I need...

I have a 28” 338 Norma Improved that I hunt with a suppressor on. The length isn’t a problem as long as you are hunting open country but...

Super jealous of that setup!! Thanks for input

That would be a barrel length of 36” with the suppressor. I personally wouldn’t want to deal with any hunting rifle that long…anywhere.

Ecco machine

Need some advice. I'm thinking of doing a 338 edge with 26" barrel. Been doing a lot of reading and sounds like I need to step up to at...

I like the science! Thank you!

Well got some h4350 and 80vld bergers I guess wish me luck.

This is from Hodgdon's website - however, those 90gr bullets are a waste of time and powder in an 8 twist. Trade the 90s for a bullet...

If you run the numbers on Berger's stability calculator the 90's are down around 1.06 with an 8twist at sea level and 59degrees 3100fps...

I'll keep those in mind if they are out of 4350. I did find a jar imr4831any thoughts on that? If I remember right that's a slow burner.

I think your right but unfortunately I got the bullets shortly after ordering the barrel. So I'm going to try it. I'll go pick up some...