Chad Schmidt's latest activity

What thread?

Stainless 29" blank 1.2" shank .725" at the end of the blank 5R Looking at their chart for sporter barrels it's between 3B & #4. Once...

Remington stainless take off barrel, brass and dies. Thought I could use this barrel on an old 721 but it won't feed out of the...

Works as it should.

Yup it sure does take you to Facebook.

I was trying to post a couple photos to explain what they showed and what I did to change it but they appear to load but there is...

I direct thread it to the adapter. It's never been lose, I do my best to have it the same tension each time. I have noticed that a small...

Prior to getting my can I read a lot about them with an eye on potential changes to accuracy. I knew the point of impact would change...

Found one load today with shock hammers that is vertical. Satisfied for the Saturday deer opener. Thanks for the information.

Proof sendero cf.

New to silencers and after about 75 rounds I see a trend I did not see unsuppressed. I get a 45* group each found going higher and...

I'm looking for a reamer for 120 gr and under bullets. A few years back I got a few thousand 90-120 gr Fowler, Browand and BIB bullets...

I'll take the 300wsm and 300prc reamers. Pm incoming.

I think I have 2 boxes of the 185's. I'll check and let you know.

Twist