cajun's latest activity

🧟‍♂️ Thread

Yeah same here. Buddy bought some nosler factory that lists 3000 with a 24”. I think with the right powder and a 22” you can get close.

I find it’s a good all around solvent that will remove copper and powder fouling if you clean regularly. If copper gets bad you may need...

That bullet is made for the 6.5 grendel and works well in a short creedmoor where velocities are lower.

Just remember hogs kill zone is farther forward. Shoot tight to the shoulder or if the near leg is back shoot just in front. A normal...

Nice!

You can get there with the 120 ballistic tip as well. Nosler has load data.

This is why I don’t like copper. At low velocity they dont do much damage. I think the op may have to use them. All the more reason to...

The problem with the 6arc compared to other 6mm’s is factory ammo and load data is limited to saami max pressure of 52k due to it’s use...

The Sako L691 is a great action with a great trigger. Glws.

Not a fan of Lee dies. Any 6mm seating die will work.

Had some rounds loaded for a couple years. Tried seating deeper and wound up crushing the shoulder. Bullets wouldn't budge. Then again...

Personally I don’t get the logic of shooting a small caliber so I can spot my shots in a situation where terrain or in this case weather...

I would check the bullets for sure.

Recently watched a video on just this subject. In a study of radio collared deer after hunting a stand and being winded or busting deer...