Recent content by buzzard

Has any one tested 175 berger's and 175 sierra's to see witch one of the match 308 is the best

I had one the dealer sent it back twice it cost me 30 bucks each time in shiping charges. Remmington did a half way job each time barley shot 2" groups at 100 I re barreled the old barrel chamber was .006 out of round

get a little mag light one You can see the copper bild up in the end of Your barrel clean all copper out of barrel shoot Your first round and look in the end of the barrel note were the bild up is You will probably see it on some lands and not on outhers as You shoot it changes this is what is...

I can't seem to find some one that has the spec.so I can compair them to My rem 700 chamber casting witch was .006 out of round makeing it impossable to get under .005 bullet run out of a chamber sized case.HELP Black Eagle

what I wanted to know was how clear are the optics? Do the adjustments work well. I can sand and paint.

Has any one heard or know of how good are bad ATN day scopes are

I tryed a lot of things that did not work this is what did Tubb's final finsh I ran it through 3 30-06's the first one shot 10 and cleaned out copper like instructions. results fair. Second one cleaned after every 3 shots to keep from laping copper results very good and the third a 700 rem. I...

David Tubb's uses and adjustable one. If You don't know who David is go to Superior shooting systems.com I use the Que Industries from brownells it's so good that browning arm's bought the rights to it. If You would like to see how it works go to browning's web site and look at the boss system video

Go to brownells.com type in muzzel brakes look at the Que Industries adjustable muzzle brake You can install it Your self with just a heat gun. browning arms co. bought the rights to this break if You want to see how it works go to there web site and they have a short video on it they call it...

speed lock fireing pin\'s I have a rem 700 and want to inprove accuracy will a speed lock fireing pin help. I just finshed a Tubb's final finsh on a rem 7400 and was inpresed surnk My grop by over and inch by the way I decopperd every three shots to keep from laping copper

I have a rem sps had to send it back two times to get a 2" grop out of it. It cost 30 bucks each time laped it the first time and re crowned the last time hope You have beter luck with Yours. if not it has a two year warranty.

I have been testing a 1903 A3 and rem 700 so far the 03 likes .040 to .050 off lands. The rem 700 shot 1" groups at .030 to .040 and it shot a 5/8" group at .100 off lands I don't think up clost to the lands is a good ida I have heard to many tails of problems

Looks like I should explain more. I have gone through a 48 round charge test and a 30 round throat depth test. Now how is the best way to tighten My grops w/ a cronograph

I just got a pact chrono w/ printer and would like some opinions on the best way to use it to inprove accuracy

I am about to by one the pro is it good