Brathany's latest activity

Barrel break-in for a factory rifle is a waste of time. Break-in for my customs I've stuck with what GAP & Krieger recommend: Clean the...

That looks nice!

The FX unit: (Edited to Add) I want to say about 6yrs ago Caldwell announced the Velociradar development. Then it was crickets, then the...

I'm a recovering knife addict...I also did a knife sharpening service for a while. That included sharpening some hundreds of China steel...

I have been reloading for over 50 years, and have never experienced any sort of cold weld. Some of the loads I have fired are over 8 yrs...

I use a S90v knife. There's no point in trying to sharpen in the field. Usually you just end up burring the blade sharp and not actually...

How do you know that about sealants? This always comes up when mentioning milsurp.

I've fired upwards to 15,000 rounds of 1970s-80s milsurp ammo, fired rounds loaded 10yrs prior, pulled bullets on many old batches and I...

Now you gone done it! That is a rather astute aspect of this.

I would assume that given an interference fit, in most cases, a barrier material would be wiped/ scraped off.

Well then. If they figured out how to make doppler calculate down range and BC, the CHIRP tech is rather superfluous.

Deer skinning gets all my pretty knives of various steels. Hogs get the replaceable scalpel jobs!

Certainly….. can I buy a life insurance policy on you? On that hunt…..will you carrying the bacon for camp breakfasts? If so, I...

I'm still on 9mm vs 45...

Snag the Worksharp.