Brathany's latest activity

You a real pressure problem when there is that much brass on the bolt face.

You only need to know seated neck diameter to determine clearance once you determine what number is going to clean up the neck, which is...

It’s not that I wanted to turn necks, but when I sized down Lapua 308 to 708, then formed to AI, I had to turn necks. Loaded OD was...

i seated them deeper as so i could go longer with heavier bullets. most fmj's ctbo are further out than match bullets for the reason...

If you want temp stable VV powders look to the N 500 series. Personally I would just develop my charge during the winter then you use...

You’ll have to tell me about those uni throaters sometime. So you like a healthy jump DTL?

when i sent in the dummy rounds i did a fl size and made sure all 3 had the same ctbo measurement. also, all 3 had the same coal. at...

Anything smaller than .012” doesn’t last long with many cycles of sizing, even with only .003” clearance, this is due to the total...

Glad to hear, well at least you can focus on your other problems now!

you are right, i have moved on and should edit those photo's out. still having problems. but you are correct, once i corrected the...

I'm fully able to comprehend what I read the first time. You bring about a point that doesn't matter. Never in my shooting career did I...

I believe it's not a "placement " only minimum and maximum, ie upper and lower. Not a mouth measurement and neck shoulder junction...

Perhaps I misunderstood what MagnumManiac said: "MagnumManiac: "To make the brass fit, it needs turning to be .014" at the upper end or...

You can't cut a taper on the K&M tool. Chambers are tapered a bit in the neck area from base to mouth. You turn a consistent thickness...

There would only be an error if my loaded neck diameter was above my target .312-.3125". When my caliper reads a case neck thickness of...