Beluebow's latest activity

A few good points here ^^^. The cutter angle should match your shoulder angle It is a good idea to turn the entire neck far enough that...

I want to give a shout out to Earl Fouraker with Lone Mountain Precision Rifles in Ennis, MT. Earl has been great to deal with, super...

Exactly my issue if I decide to change. Not really pinching Pennie’s. Maybe the inlet to M5 won’t be as much as I think it will be. As...

wELKome!!

Hello and thanks for letting me join your forum! By trade, I'm an Automation Engineer, which at my current employment means I program...

I don't need another rabbit hole......I don't need another rabbit hole.....I don't need another rabbit hole........Sounds fun!!

IMO might as well do a 100% percent clean up since you're already doing the work. but a skim turn is fine also. If your cutter matches...

20 inch is fine. 8 twist if you run the 75-80 grain bullets. In a 20 you should be at about 3200fps. I run 88’s in my wife’s 26 inch gun...

Congrats!

Harvested my first PA Black bear Saturday opening day. While SLOWLY walking to my stand opening day at appx 7:20AM, I was walking down...

I know someone just like him, grouchy and mean, grumbling every morning about what hurts today. Just wish he didn't look at me in the...

Buy him a new rifle and see if he’s easier to be around!!

I’m working on one at the moment, but it doesn’t seem to help lol

I never tip my processor. He is an a hole ,very angry ,and hard to get along with! Now with that being said I do all my own processing!

In the 90's through early 2000's there was a Amish group that processed deer near Selma Ala.that hunters drove up to two hours to get...