ARlife4me's latest activity

Sounds cool. Know I will never see but would sure like to. Best wishes and good luck.

kinda like shooting in the house......

If that's thecase already, then no it isn't going to help like you stated.

Depending on where you are on charge range, seating deeper w/o adjusting charge can be a catastrophe.

That is a QUESTION FOR A INMATE ????LOL 🤷‍♂️ 🤪🤪o_O

oh well! i have a lot worse people living next door to me. forums are easy! i replied because he's been busy and sometimes isn't...

Because you asked him, you literally quoted ARlife4me in your question. There is no reason for this behavior.

ideally going from short mag to long mag saves more barrel w/o the need to cut off tenon when going to a longer cartridge? that would...

The area larger above the chamber on a barrel, this is the technical term. Of course, no taper barrels don’t have one. This term...

Following

Unless you exceed the standard length of the barrel maker's steel, there should be any additional cost. I've been ordering and making...

I shoot a 284 Shehane, so rebated rims don't bother me. Superior brass(Lapua) is a bonus for me, as well as not needing a magnum bolt...

I already shoot a BR in a couple match rifles, and will be spinning up s 22BR for this winter, so I already have brass(expendable...

i will not go into the problems i,ve had with lee dies and shell holders. but i will not buy anything mad by lee! i needed dies for a...

It’ll be .700” or .705”, but I don’t see any cartridge with that case rim. 700 Nitro is .780”. Haven’t got a clue…. Cheers.