Taj

I use Devcon on synthetic stocks and match rifles and Acraglass ( spelling? The Brownell's stuff) on wooden hunting stocks for no other...

Very nice work!!

Official SCI score is 94 6/8. Largest single horn recorded.

Changing the chamber is not going to change the twist rate of the barrel, if it’s a slow twist 270wsm it will be a slow twist...

I have seen plenty of "gunsmiths" make the extractor cut on a model 70 a straight (flat) cut, from the chamber mouth to the outside of...

Extractor cut is needed because of the coned breach. Many later Mauser copies do not require the extractor cut because the breach face...

Taj That looks Very Classy. A fine job. Hal

We do all of our caliber markings on chrome-moly or SS .003 unless the customer specifies diff. If we do it on a Cerekoted gun it is...

Taj, I own a German FN in 30 06. With a Heinzholt Scope. Tons of hand engraving on the receiver and floor plate and scope rings ...

Thanks much.

That's what is nice about the laser. We took cut off's of SS and chromemoly barrels and burned a large "swath" into so we could actually...

Thank much. Trying to fit an outline of the the State of Idaho on an ax head so it's recognizable was "twicky" but looks kinda cool.

Thanks very much.

To the best of my knowledge there are none. I'll usually burn it about .002 to .003 deep. That way if they are going to Cerakote it , it...

Here is the caliber marking for a .275 Rigby I'm building and an ax I just did for another customer.