WahooYahoo

Standard 243W can be a little hard on throats, but the 243AI reduces throat wear by a fair margin. 6CM doesn't give up a lot to the 243...

If your rifle is shooting 1/2 moa with factory ammo the biggest challenge you will face is finding a load it likes and it will likely...

I quit weighing and over-analyzing my brass. It was a necessary and timeconsuming part of my process when I used factory or mixed...

Sig tends to get a lot of contracts that way with an inferior product in some cases. I'm not a fan.

What were you expecting? Factory rounds are loaded down at AR pressures. Putting the ARC in a boltgun with the 20-22” barrel along with...

Three main reasons I choose 6 ARC over a fast twist 243 1) Barrel life: 6 ARC is expected to get 5K rounds on the bore. My 6 ARC is my...

I hear often there are “better 6mm options” in a bolt gun. Often the 6mm Creedmoor and 243 are mentioned, but both cartridges have 1/4...

In a bolt action, the 6 ARC delivers a heavy for caliber 6mm bullet that can kill deer beyond 500 yards. Recoil is a tad more than a...

I noticed no difference at all whether I turned the necks or not, weight sorted the cases or not, wished upon a star or not. But I...

I see a lot of folks have good results with this method. I will add you can have forster hone a die your specs so your die is not...

It's interesting to read about everyone's process. Mine has evolved over the years, and at one point or another, I've tried just about...

I don’t use bushings. I mostly run Forster dies with micrometer seaters.

I use FL dies and pull the expander stem. Run them trough a mandrel to expand the necks. I deprime with the Frankfort Arsenal hand held...

You will want to take out the expander ball if you are using a mandrel die (I love them for LR loads but don't bother with non-LR...

Not sure what email you are using but I’ve gotten quick responses from them twice asking about my order for the exact same scope. FYI...